Instruction manual

Instruction Manual Page 12
EDIsecure
®
XID 8300 Ethernet Status Monitor
 Resin K Ink Print Mode: For setting the print quality using the Resin K ink. Selecting “Fine”
enhances the printing quality, but slows down the printing speed.
 MG Print (JIS): For specifying the way to peel the retransfer film of cards that come with a JIS
magnetic stripe when the JIS MG unit is mounted. The default setting is “Disable”.
 Standby Mode: For specifying the card standby position while waiting for the laminator to
switch to the Ready mode during double-sided printing when the laminator is connected. The
default setting is “Front Wait”.
 Cooling Time: For specifying the standby time in units of seconds before peeling the
retransfer film from the card after retransfer is complete. The default value is 0.
 MG Unit
 Number of Retry: For specifying the maximum number of retries when writing/reading of the
magnetic stripe fails. The default value is 1.
 ISO Mode: For specifying the coercivity with respect to the ISO magnetic stripe. The default
setting is “Hi-Co”.
 Encoder Unit
 Contact IC Encoder: For specifying the contact position of the contact IC encoder. The default
setting is “None”.
 Non-contact IC Encoder: For specifying the antenna position of the non-contact IC encoder.
The default setting is “None”.
 Others
 Buzzer: For enabling/disabling the alert sound when error occurs or when the card quantity is
running low, as well as the sound upon pressing the Enter key in the user mode. The buzzer
does not sound if you disable this feature. The default setting is “Enable”.
 Power Saving Interval: Enables switching to the Power Save mode to reduce power
consumption when printing or operation is not performed over a specified time interval. Select
whether to disable the Power Save mode or the time interval before switching to the Power
Save mode. Selecting “Disable” deactivates the Power Save mode. The default setting is
“Disable”.
 HR Control: Switches to the standby mode by lowering the temperature of the retransfer heat
roller when printing is not performed for 30 minutes or longer. The default setting is “Enable”.