User guide

11: LDVR-3U Installation Procedures
92 —
revision 38
Note: If firmware is detected, you are prompted to remove the firmware and should
do so.
5. Specify the storage path. Typically this is the default setting
D:\LDVRStorage\. Click the [Next] button.
6. Select NTSC or PAL when prompted. Click the [Next] button.
7. The firmware is installed. Click the [Finish] button to complete the
installation process.
8. When prompted to reboot your machine, click the [Yes] button.
Note: If you will also need to run the Multi Volume Configuration application, you
can save time by running the Multi Volume Configuration application before
clicking the [Yes] button in this step.
9. You should (re)/download settings to this recorder via the System
Administration application before using the recorder.
a. In the System Administration software application, select Video >
Digital Video from the menu options.
b. Open the Video Recorder form and right click on the recorder.
c. Select Download from the drop down list of menu options.
d. Click the [OK] button.
Add Hard Drive Volume(s) to Video Storage
The Multi Volume Configuration application is used to specify new hard drives.
This application is not required when you upgrade existing hard drives or replace
bad hard drives.
The Multi Volume Application is also used to temporarily remove hard drives
that are being worked on (upgraded or replaced). This procedure is necessary so