User guide

Digital Video Hardware User Guide
revision 38 — 85
5) Perform the steps in Configure the RAID Controller Board BIOS to
ensure that the RAID controller BIOS settings are what they should
be according the to LDVR-3U configuration being set up.
6. Right-click on My Computer and select Manage from the pop-up menu.
7. Click on Disk Management. The Disk Management applet will appear in
the right window pane of Explorer.
8. When the Write Signature and Upgrade Disk Wizard appears, click on
the [Cancel] button.
9. If the CD-ROM is not labeled as drive Z:
a. Right-click on the CD-ROM drive (CDRom 0) and choose the option,
Change Drive Letter and Path…
b. Click on the [Edit…] button.
c. Change the drive letter to Z:.
d. Click on the [OK] button. A confirmation message will appear.
e. Click [Yes].
10. If any disk is labeled “Unknown,” right-click on it and then select Write
Signature from the pop-up menu.
11. If any disk is labeled “Basic” then:
a. Right-click on a Basic disk and then select the option, Upgrade to
Dynamic Disk…
b. Choose to upgrade all the disks to dynamic disks by checking their
boxes.
c. Choose to upgrade all the disks to dynamic disks by checking their
boxes.
d. Click on the [OK] button.
e. Click on the [Upgrade] button. A confirmation message will appear.
f. Click [Yes]. You will be asked to restart the unit.
g. Click [Yes].
h. Click on the [OK] button in the dialog box that follows. The unit will
restart.
i. Once the unit is started, log in (as a local Administrator). You will be
prompted to restart.
j. Click [Yes].
k. After restarting, log back in.
l. Right-click on My Computer, select Manage from the pop-up menu,
and click on Disk Management.
12. For the currently unallocated portion of Disk 0:
a. Right-click on that portion and then select Create Partition… from the
popup menu that appears. The Create Partition Wizard should appear.
b. Click on the [Next] button.
c. Leave the partition type set to the default (Primary) and click on the
[Next] button.
d. Leave the Amount of Disk Space to Use field set to the default (which