User guide

11: LDVR-3U Installation Procedures
82 —
revision 38
pressing the <Enter> key.
Use the arrow keys to navigate through the menu system.
b. Navigate to the Advanced main menu option, then to the Boot
Configuration option and press the <Enter> key.
c. Change the Plug & Play O/S option to Yes and then press the <Esc>
key.
d. Navigate to the Peripheral Configuration option and press the
<Enter> key.
e. Change the parallel port detection from Auto to Enabled.
f. Change the parallel port mode to ECP.
g. Disable the audio device. This will allow people to hear an audible beep
when the LDVR-SP firmware starts/stops.
h. Press the <Esc> key. Navigate to the USB Configuration section with
the down arrow key and then press the <Enter> key.
i. Disable High Speed USB and also Legacy USB support and then press
the <Esc> key.
j. Navigate to the Security main menu option and then set the supervisor
password to LENELDV.
k. Navigate to the Boot main menu option with the right-arrow key.
l. Disable the Silent Boot and PXE Boot to LAN options. These two
options conflict with the RAID controller board. If either of them are
enabled, you won't be able to enter the RAID controller BIOS setup
screen (3ware Disk Array Configuration utility).
m. Navigate to the Boot Device Priority section with the down-arrow key
and then press the <Enter> key.
n. Set the boot device priority to the following (which is set up by selecting
device #2, pressing the <Enter> key and then choosing the ATAPI CD-
ROM device):
• Removable Dev
•ATAPI CD-ROM
• Hard Drive
5. Press <F10> and choose to save your changes
6. Restart the unit.