User guide

Digital Video Hardware User Guide
revision 38 — 53
Chapter 7: LDVR-SP Storage and Maintenance
To prevent malfunctions of the LDVR-SP due to dirt (e.g., dust particles, smoke):
• Position the LDVR-SP in a room with limited access.
• Consider installing an air cleaning system where the LDVR-SP is located if
the general environment is dirty.
• Avoid positioning the LDVR:
– Near doors or walkways that are used frequently
– On or near the floor, or any surface that tends to collect dust
– Near printers or paper products that create dust
– In smoking areas
Recommended Environment
The LDVR-SP is configured with an Intel Active Monitor. This tool monitors
sensors on the motherboard and alerts you if the temperature or voltage level is
outside of the threshold range. You can also view system reports, on the current
value of each sensor and its threshold limits, historical reports on alert
notifications as well as, set sensor thresholds and active alert notification options.
The standard alert notification symbol is the Intel Active Monitor icon in the
system tray, which turns red and flashes in the event of an alert. Additionally, you
can choose to receive audio alerts and pop-up window alert messages.
Note: Right-click on the Intel Active Monitor icon to enable/disable active
alerting.
Temperature
The following are minimum and maximum temperature limits for LDVR-SP
operating and storage conditions. Because the LDVR-SP generates heat, the
ambient room temperature should be much lower than the recommended
maximum temperatures. To prevent overheating, avoid positioning the LDVR-SP
in direct sunlight, near heaters or heating system outputs.
Operating conditions: 5° to 40°C (40° to 110°F)
Storage conditions: -40° to 65°C (-40° to 149°F)
Note: To view the temperature and speed fan via the Intel Active Monitor, click the
icon in the system tray, and click the [Cooling] button. To change the
temperature settings from Celsius to Fahrenheit, click the [Options] button.