User guide

Digital Video Hardware User Guide
revision 38 — 49
Note: To determine the IP address, click the Windows [Start] button and select
Programs > Accessories > Command Prompt. Type ipconfig.
2. If the connection is not made, check to be sure that Remote Desktop Sharing
is enabled and activated.
3. If the connection is made, type in your user name and password. Remote
Desktop Sharing will be established.
4. A meeting window will be displayed. Click on [OK].
5. Stop services on the remote machine.
6. In the NetMeeting menu, select Tools > File Transfer, or click on the File
Transfer button.
7. A new window appears, allowing you to copy the firmware file to the remote
machine.
8. Locate the file on Disc 2, under LDVR-SP Server Setup\setup.exe.
9. Click on the [Add] button to add the file to the list of files to send over to the
other machine.
10. Under the File menu, select Send All.
11. There should be a confirmation message when it is done. Click on the
[Open] button and the installation should start.
12. Once the file is transferred, follow the procedure for upgrading the LDVR-
SP using the transferred file instead of the file on the CD (start from step #3
of the following procedure).
Install LDVR Firmware through a CD
Keep in mind that when upgrading B.A.S.I.S., all LDVR units must be upgraded
as well. The supplied LDVR-SP firmware installation/upgrade can be found on
Disk 2.
1. Insert the CD into the LDVR.
2. Stop the Lenel Digital Video Server as well as the Linkage Server,
Communications Server, and Archive Server.
3. Run the program, LDVR Server Setup\setup.exe, located on Disk 2 of the
B.A.S.I.S. CD set.
4. The welcome screen is displayed. Click the [Next] button.