User guide

Digital Video Hardware User Guide
revision 38 — 41
Physically Add or Replace Digital Video Capture Card(s)
1. Remove the chassis cover.
2. If you are replacing existing video card(s) remove the old video card(s).
3. Insert the new video card(s) in the order listed below, where PCI slot #1 is
the slot closes to the CPU.
8-channel digital video capture board configurations:
• RAID controller board in PCI slot #6
• DV-8UP-S in PCI slot #1 (for video channels 1-8)
• DV-8UP-S in PCI slot #2 (for video channels 9-16)
• DV-8UP-S in PCI slot #3 (for video channels 17-24)
• DV-8UP-S in PCI slot #4 (for video channels 25-32)
4-channel digital video capture board configurations:
• PCI slot #1 is empty
• RAID controller board in PCI slot #2
• DV-4UP-30F in PCI slot #3 (for video channels 1-4)
• DV-4UP-30F in PCI slot #4 (for video channels 5-8)
• DV-4UP-30F in PCI slot #5 (for video channels 9-12)
• DV-4UP-30F in PCI slot #6 (for video channels 13-16)
4. Power the unit back up.
Physically Add, Upgrade, or Replace Hard Drive(s)
If a back up is not done, you will lose ALL of your digital video data.
Upgrade the hard drive AFTER all digital video data has been backed up.