User guide

4: LDVR-SP Hardware
30 —
revision 38
Video comes in from the camera into the “In” connector, then is transferred to the
recorder through the 25-pin connector. It is then sent to the monitor or VCR
through the “Out” channel.
Notes: The active video splitter is powered with a +12 VDC (500 mA) power
supply connected in the back of the unit.
The 25-PIN connector plugs into the PCI slot on the back of the LDVR-SP.
Each active video splitter has the capacity for eight camera inputs, a total of
four per LDVR-SP.
Install the Active Video Splitter
8-channel digital video capture boards
1. There are two 25-pin connector ports in the back of the active video splitter.
To install this device, connect the 25-pin connector from port 1 on the back
IN OUT IN OUT IN OU T IN O UT IN OU T IN OUT IN O UT IN O UT
CH8
CH7
CH6
CH5
CH4 CH3 CH2 CH1
CameraCameraCamera
Analog CCTV
Monitor
GO!
(Back)
Port 1
Power
19"
1.75"
3
"
Port 2
(Front)
25-pin connectors
Coaxial
cables