User manual

[e-mail] Page | 6 1-800-930-0949
Bottom View
The bottom of the camera shows the wired/wireless MAC addresses of the camera. It also shows
the S/N number and has a reset button.
If you ever need to reset your camera to default settings, you can use the reset button. Use a pin to push
down the reset button for 10 seconds. Make sure the camera is plugged in and turned on. When the
camera hard resets, it will start to pan and tilt automatically, this signifies that the camera has reset
completely. You should be able to log in with the default username of “admin” with no password in the
password field.
Note: There are three stickers at the bottom of the camera; these stickers are an important feature of
original Foscam cameras. If your camera does not have any of these three stickers, it may be non-
genuine. Non-genuine cameras cannot use original firmware and are not eligible for warranty or technical
services. Please make sure you only purchase from an authorized Foscam reseller!