User manual

[e-mail] Page | 51 1-800-930-0949
6.15 – PTZ Settings
This page allows for changing any speeds of the camera’s pan/tilt abilities or default positioning of the
camera.
Disable Preset – This option will allow you to disable presets on the camera. If you would like to use
presets, uncheck this box. If unchecked, the second feature “Go Center on Boot” will change to “Go to
preset on boot.” What this feature does is allows you to choose whether you would like the camera to
point a certain way when it reboots or is powered on again.
To have the camera point to a preset, make sure disable presets is unchecked. Set a preset to preset #1
on the live video page. Once you have set the preset, come back to the PTZ Settings page and check
“Go to preset on boot.” Remember, this option will only be available if “disable preset” is unchecked.
Go Center on Boot – This option makes the camera pan and tilt automatically once it is rebooted or
restarted. Uncheck this box if you would like the camera to remain stationary when it is rebooting.
PT Speed – This option allows you to control how fast or slow the pan and tilt speed is of the camera. A
lower value here makes the camera faster. A higher value makes the camera move slower.
Patrol speeds – For patrol speeds, the same concept applies. A lower value here will make the patrol
speed faster, while a higher value will make the patrol speed slower.
Patrol rounds – These settings allow you to control how many rounds the camera will pan or tilt on a
horizontal or vertical cruise. If this value is set to 1, the camera will tilt or pan from the current position
once to the right/top, then it will tilt or pan left/down, and then come back to the center.
Remember to push Submit to save these settings; the camera may have to reboot depending on which
settings are changed.