User manual

[e-mail] Page | 50 1-800-930-0949
Send Mail on Alarm – If you would like to set up e-mail notifications, check this feature to have e-mails
sent every time motion is detected. If this feature is not checked, you will not receive any e-mail alerts.
Make sure your information on the Mail Service Settings page is filled in correctly.
Upload Image on Alarm – This setting allows you to upload images using the FTP settings you have set
in FTP Service Settings. You can set the upload interval here as well in seconds.
Upload interval – The interval time between two uploaded pictures.
Beep on Alarm – If you select this checkbox, you can hear a beeping alarm when motion or sound is
detected on the browser.
Record on Alarm – If you select this checkbox, the camera will record automatically when motion or
sound is detected to the path specified in the User Settings.
Alarm Record Filepop – This icon controls the pop-up folder feature. When a recording is complete, the
software automatically opens up the folder that the recording was stored in. Uncheck this to stop the
folder from popping up every time there is a new recording.
Scheduler – The scheduler allows you to set certain time periods when you would like motion to be
detected. You can use the scheduler to set times for all 7 days of the week, 24 hours a day. Each
rectangular block in the schedule represents 15 minutes. You can use this system to specify when you
would like to enable motion detection and keep it disabled.
You have the option of not checking scheduler. If you uncheck scheduler, motion detection will be
activated at all times, as long as motion detection is armed.
Clicking the number (that corresponds to the hour) at the top of each column will set motion detection for
that specific hour during the entire week. You can also clear the zones by clicking the number below the
top number.
For example, in the screenshot above you can see that during the entire week, at 3:00 AM – 4:00 AM,
and from 5:00 AM – 6:00 AM, motion detection will be activated. At all other hours during the week,
motion detection will be deactivated.
You can click “Set All” at the top of the scheduler to set motion detection to all the zones easily. You can
also use the button “Clear All” to clear the entire board of any activated zones.
Be sure to click “Submit” when you are finished setting all motion detection settings.