User manual

[e-mail] Page | 40 1-800-930-0949
Next, press the WPS button on your router within 60 seconds. The WPS button is usually on the back or
on the side of your router. On some routers, you may need to log in to the web interface and click on an
on-screen button to activate the WPS feature. If you are not sure where the WPS button is on your router,
please refer to your router’s User Manual.
The camera will automatically create a secure wireless connection to your router. If you have plugged in
the network cable, you can disconnect it at this time. While connecting, the green network light will blink
quickly and the wireless settings will take effect. The IP Camera Tool will search for the camera’s LAN IP
address. Make sure that the PC and the camera share the same subnet.
NOTE: When setting up the WPS Settings, you must press the Reset button only for four seconds, or
else the camera may reset itself back to factory default settings if you press and hold the reset button for
10 seconds or more.
For WPS, the security mode of the router cannot be WEP, or else the WPS settings may fail.
Adhoc Mode
Using this mode, the Foscam camera will directly connect to a host in a peer-to-peer environment.
Make sure the PC has a wireless network card plugged in. Enable the wireless on the wireless LAN
settings page and choose Adhoc mode.
Fill in an SSID to identify the Foscam camera and then set the security mode, you can choose none or
another type of encryption. Click Submit.