User manual

[e-mail] Page | 33 1-800-930-0949
Once you finish adding a camera, click “Add.” You can then proceed to add additional cameras until you
are finished. Once you have added all cameras, click the “Submit” button to save settings.
Note that you will only be able to see the added cameras on your local network, if you try to access your
cameras remotely, you will not be able to see them unless you change the Local IP addresses to External
IP addresses (this is explained further in the Quick Installation Guide). If you would like to see the
cameras remotely, instead of putting the LAN IP address of the camera, you will need to change this to
your External IP address (which can be found at www.whatismyipaddress.com) or your DNS hostname if
you are using a DNS service (make sure to exclude http:// from the hostname).
An example of 4 cameras set up using Multi-Device Settings