Technical information

C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
G
G
u
u
i
i
d
d
e
e
o
o
f
f
H
H
.
.
2
2
6
6
4
4
I
I
P
P
c
c
a
a
m
m
e
e
r
r
a
a
a
a
n
n
d
d
V
V
i
i
d
d
e
e
o
o
S
S
e
e
r
r
v
v
e
e
r
r
P
P
r
r
o
o
d
d
u
u
c
c
t
t
s
s
1. Preparation for the connection
1
1
.
.
1
1
.
.
P
P
r
r
o
o
d
d
u
u
c
c
t
t
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
Brief information for rapid installation is provided in this section. For more detailed information,
you are recommended to refer to pertinent documentations provided with the product.
1. Apply Power to the device and connect with Network.
AC adapter which is compliant to the specification for products should be used. Misuse of power supply
can cause damage to products. Speco Technologies assumes no responsibility for misuse of the power
supply.
- Non-Standard Power Connection will cause critical damage to products.
- Varieties of power supplying option are provided for each of the product.
Please refer to the manual of each specific product for available option.
2. Install “IP-Installer (Ver.3.0.1 or above)” and “Speco-NVR (Ver.5.0 or above)”
on your PC.
Speco-NVR installation also includes IP-Installer installation. Detailed information for
installing these programs can be found in [Speco-NVR User’s Guide], respectively.
3. Assign IP address to the product using IP installer.
Identify the type of the network environment and set up IP address. If network type is xDSL
or Cable modem you need supplementary information provided by your ISP.
< Quick IP Installer Installation Guide >
A. Starting IP Installer
To starting IP Installer, select “Start Up”  “Programs”  “Speco Technologies”  “IP
Installer” at the Windows task bar.
B. Find the Device for the Configuration
Click on “Refresh” button to list up all IP Products (IP Cameras or Video Servers)
connected on the same network with the PC and identify the products with MAC
Address.
ⓒ 2011 Speco Technologies
5
Rev.1.5