User manual

34
12000 Ford Road, Suite 110
Dallas, TX 75234 Tel: [phone] Fax: [phone]
www.idview.com
Pic: 4.17 PPPOE
Enabe：Tick means chosen, enable it firstly, then the setting is valid
Input user name and password that provided by ISP（Internet server provider）, save it and reboot
device, after reboot, IPC will auto connect to network by the way of PPPoE, if it is successful【IP
address】will be changed to the dynamic WAN IP that just get.
Operation：PPPoE dial up successfully，check【IP address】，to get current IP of device, then access
this device by this IP from client side.
【NTP setting】
Pic: 4.18 NTP setting
Need to install NTP service at PC
Enable：tick means chosen, setting is valid only when it is enable.
Server IP：input IP of PC that installed with NTP server
Port：default NTP port is 123，can base on the actural NTP server to set port no
Time zone：London GMT+0 Berlin GMT +1 Cairo GMT +2 Moscow GMT +3 New Delhi GMT
+5 Bangkok GMT +7 Hongkong/Beijing GMT +8 Tokyo GMT +9 Sydney GMT +10 Hawaii