User manual

24
12000 Ford Road, Suite 110
Dallas, TX 75234 Tel: [phone] Fax: [phone]
www.idview.com
Pic 4.6 Time Period setting
【Interval】Only one alarm signal is turned on even there are several motion detect signals in the set
interval 0-600s.
【Alarm output】Start the external equipment of corresponding linkage alarm when the motion detect
alarm is turned on.；
【Delay】Delay a few moments and stop when the alarm state is turned off. The range is 10~300
seconds.
【Record channel】choose record, when alarm happens, system will trigger record signal of this
channel；
Remark:to link record, need to enable motion detect of related period at【record setting】
【Snapshot】choose snapshot, when alarm happens, system will trigger snapshot signal of this channe；
Remark：to link snapshot, need to enable motion detect of related period at【record setting】【record
setting】
【PTZ Linkage】when alarm happens, link the PTZ of related setting channel, see pic:4.7；
Remark：to link PTZ, need to set related parameter at【System】>【PTZ control】， set preset
point, cruise between points, interval, etc.