Users Manual

can restart engine by applying brake and pressing the start button.
Tachless Mode
Non-Diesel Vehicle:
⚫ Apply the brake and press -and-hold the start button to START. The starter cranks so long as the
button is being pushed ( up to 6 seconds). This can be done from any mode (OFF, ACC or ON).
⚫ Alternatively in an emergency situation, without applying the brake while in OFF state, press-and-hold
the start button for 3 seconds to engage engine to START, release button after engine started.
⚫ If your engine failed to start after you released the Start Button, the system will have entered RUN
mode and you must press the Brake and then hold the Start Button to exit the RUN mode before
attempting to restart the engine.
Diesel Vehicle:
Without applying the brake while in OFF state, press and release the Start Button twice to turn the ignition
ON, wait till the Glow Plug Light goes out, then apply the brake and press -and-hold the start button to
START.
To Turn Your Engine OFF
⚫ Apply the brake then press-and-hold the start button for one second to turn OFF the ignition.
⚫ Alternatively in an emergency situation, without applying the brake, press-and-hold the Start Button
for 3 seconds to turn OFF the ignition.
10. Authorization of PSB Module
This allows us to use the PBS module as a standalone product with an existing alarm. The existing alarm provides
either a Ground when Armed or Ground when Disarmed as the authorization signal. Selected via Dip Switch DP2 on
DIP3. Detailed below:
DP2 on DIP3 in UP (OFF) position: Authorization when Grounded. * If the PSB sees a Ground Pulse on the purple
wire the PSB should Authorize for 60 Seconds. ** If the PSB sees a Ground Latched, the PSB should Authorize for as
long as the Ground signal remains on the purple wire.
DP2 on DIP3 in DOWN (ON) position: Authorization when Ground disappears from purple wire. The PSB should
not operate when the purple sees a ground, but should authorize when the Ground signal disappears.
11. Remote Start
With the iKey outside the proximity sensing range, press and hold the TRUNK RELEASE and LOCK
buttons for 3 seconds. The parking lights and siren (if enabled) will flash and sound 1X to indicate remote
start signal received. After 5 seconds the system will attempt to start the engine. If vehicle does not start at
the first attempt (i.e. cold engine start), system will attempt to start the engine up to 3 times. Once started
vehicle will run for 15 minutes---parking lights will remain ON during this period.
Note:
1. Press and hold the TRUNK RELEASE and LOCK buttons for 3 seconds to shutdown the remote start.
2. For diesel vehicle there will be a delay while the vehicle’s Wait-to-Start Light is ON. After 18 seconds the
system will proceed to start the engine regardless.
3. The engine will shut down after remote start if the RPM is too high. ( Example: If floor mat got stuck on gas
pedal.)
4. If Hood is not closed the remote start will fail.
5. Remote cannot be proceeded before performing Tach Learning.