User manual

Blackfin DEV-BF548-Lite. DEV-BF548DA-lite Hardware User Manual

This procedure has to be done twice, because at first the USB driver will be installed. Then the

Hardware Wizard opens again, because the UART bridge driver has to be installed in addition

using the same driver file. Simply repeat this step.

5. Open the Windows device manager (Control Panel  System  Hardware) to see which COM

port number has been assigned to the CP2101 UART-to-USB Chip. This number differs from

computer to computer based on the already installed COM ports. (e.g. COM4)

6. Open a Terminal program like the HyperTerminal included in Windows operating systems and

open the respective COM port with 115200 Baud, 8 Data-bits, No Parity and 1 Stop bit,

disable the Hardware flow control.

7. Reset the DEV-BF548-Lite Board (Press the main reset button). After this you will see the

BLACKSheep boot-screen showing up. If you disconnect the device, you have to reconnect.