User manual

Blackfin DEV-BF548-Lite. DEV-BF548DA-lite Hardware User Manual
23
1000 Reserved
1001 Reserved
1010 Bootfrom(DDR)SDRAM
1011 BootfromOTPmemory
1100 Reserved
1101 Bootfrom8‐ or16‐bitNANDflashmemoryviaNFC
1110 Bootfrom16‐BitHostDMA
1111 Bootfrom8‐BitHostDMA
Table 6-1: Boot modes
7 Installation
7.1 Initial Board Setup
The installation guide is written for Windows (Windows 2000 and WinXP). However for connecting the
USB device the driver for MAC and LINUX are available on the CD.
In order to set up und test your DEV-BF548-Lite board the following steps can be done:
1. Make sure jumpers JP2 and JP3 are set and the Switch S3 is in Position 1. as shown in Figure 7-1
(JP1 unset).
Figure 7-1: Setup of the DEV-BF548-Lite Board
2. If you want to use an SD-Card, insert the SD-Card in the appropriate slot at the bottom side of
the board.
3. Connect the power supply to the power connector off the DEV-BF548-Lite board.
4. Connect the DEV-BF548-Lite Board via USB to the PC. The pre-flashed BLACKSheep starts and
the LED mounted on the DEV-BF548-Lite board starts blinking. On the PC usually the ‘Found
New Hardware Wizard’ opens.