Technical data

70 RZ56 Storage Expansion Box
6.4.4 BA42 Enclosure SCSI ID Switchboard
The SCSI ID switchboard is on the inside back wall of the expansion box.
It contains two switch packs. It connects to the smaller connectors on the
RZ56 drives by a cable. Follow this procedure to remove the switchboard,
and reverse the procedure to install it.
1. Switch off power to the expansion box.
2. Unscrew the two cover screws and remove the expansion box cover
3. Disconnect the cable from the SCSI ID switchboard (Figure 6–12).
MA-X0573-89
SCSI
SWITCH
MODULE
Figure 6–12 BA42 Enclosure SCSI ID Switchboard Location
4. Remove the SCSI ID switchboard from the two standoffs and lift the
board from the expansion box.