Technical data

66 RZ56 Storage Expansion Box
3. Mount the drive in the drive’s mounting holes and secure by
tightening the mounting screw (Figure 6–9).
MOUNT
HOLES
MOUNT
HOLES
MA-X0963-89
Figure 6–9 BA42 Enclosure Drive Mounting Position
4. Install the cover and tighten the two cover screws.
6.4.2 Removing the Drive’s Electronics Module
Before you can remove the electronics module, you must remove the drive
from the storage box. Refer to Section 6.4.1 to remove the drive from the
storage box.
Removing the Bezel
To remove the bezel:
1. Orient the drive with the module face up, and turn the drive so the
bezel is facing away from you as shown in (Figure 6–10).