Technical data

58 RZ56 Storage Expansion Box

Code Description

00000001 Good results. There is no error for the drive located at the SCSI

address ID. The SCSI ID is set by depressing the switches on the

back of the storage expansion box (should be ID 0 and/or ID 1).

FFFFFF03 This code is reserved for the SCSI bus controller and should never

appear in the drive’s SCSI ID address. If this code does appear in

the ID address of the drive, check the SCSI ID settings on all drives,

then replace the MSC module if each drive is set properly.

FFFFFF05 The drive is either not installed, not powered up, not connected to

the SCSI port properly, or is faulty.

FFFFFFFF The drive was not tested because of a fault with the SCSI bus

controller on the MSC module.

System Exerciser Results

The following table shows the results of the system exerciser when in

the ﬁeld service mode. The code for the drive shows that it is writable

and that no errors are present. Any error code other than those listed

indicates there is most likely an error on the disk, but never rule out the

possibility of an error on the SCSI bus controller itself.

Code Result Drive location

0200.0001 No error SCSI address ID 0

1200.0001 No error SCSI address ID 1

2200.0001 No error SCSI address ID 2

3200.0001 No error SCSI address ID 3

4200.0001 No error SCSI address ID 4

The SCSI ID is set by the switches on the back of the storage expansion box.

If the Tests Indicate an Error

If the tests indicate an error:

1. Make sure the storage expansion box has power and is switched on.

2. Make sure the SCSI port cable connects properly to the back of the

RZ56 storage expansion box and to the external SCSI port on the

system box, or to the previous storage expansion box.