Technical data

VAXstation 3100 (Model 38) System 47
4.12 Battery Pack Removal
To remove a battery pack:
1. Remove the system box cover (Section 4.3).
2. Remove the drive plate (Section 4.7).
3. Disconnect the battery cable from the system module (Figure 4–19).
BATTERY
CABLE
BATTERY
PACK
MA-X0807-88
Figure 4–19 Battery Cable Location
4. Remove the battery pack from its holder.
NOTE
A new battery needs a minimum of 25 hours of continuous
power to fully charge the battery. If the battery’s charge is
low, you will see an error for the NVR (0000.0005) when you
power up the system.