Technical data

46 VAXstation 3100 (Model 38) System
3. Place the new system module in the system box making sure the
connectors slide through the openings in the rear of the system box as
shown in (Figure 4–18).
Power Cable
Panhead Screws (3)
Locating Post
Battery Cable
Panhead Screws (5)
Locating Post
MLO-003309
MA-X0873-89
Figure 4–18 Installing the System Module
4. Push the module toward the back of the box until the front set of
holes on either side of the module fit on the two locating posts on
the bottom of the box. You must apply some pressure because of the
elasticity of the connector shieldings surrounding the connectors at
the back of the module. Snap the module on the locating posts.
5. Check that the screw holes are aligned. Install and tighten the eight
panhead screws.
6. Plug in the battery cable.
7. Plug in the power cable on the system module.
8. Connect the MSC cable to the MSC connector on the system module.
9. Reinstall the drive plate in the system box.
10. Connect the MSC cable to the MSC module.
11. Connect the power cable to the drive’s power cable harness.
12. Reinstall the system box cover.