Technical data

40 VAXstation 3100 (Model 38) System
4.9 Graphics Coprocessor Module Removal
To remove the graphics coprocessor module:
1. Remove the system box cover (Section 4.3).
2. Remove the drive plate (Section 4.7).
3. Remove the graphics coprocessor module from the four standoffs
(Figure 4–12).
4. Grasp the module near the two connectors under the module and lift
it off the system module.
Standoffs
Graphics Coprocessor
Module
Standoffs
Connectors Underneath
Module
MA-X0870-89
MLO-002914
Standoff
Figure 4–12 Removing the Graphics Coprocessor Module
5. To install a new graphics module, reverse the removal procedures in
Section 4.9.