Technical data

VAXstation 3100 (Model 38) System 35
NOTE
The RX23 drive plate lever may have shipping material under
it. If it does, remove the shipping material and discard it
before performing the next step.
3. Simultaneously press down on the drive plate lever under the RX23
and slide the drive toward the lever until you can lift the drive from
the plate.
4. Locate the SCSI ID switches 1, 2, and 3 on the side of the RX23 as
shown in (Figure 4-9).
Record the SCSI ID switch positions so you can set the ID switches
on the replacement RX23 to the same positions. Usually, the switches
are set to 5, as shown in (Figure 4–9).
MLO-002886
Down (On)
Up (Off)
1 2 3
1
2
3
Switches Positions:
SCSI ID 5
MA-X0851-89
Mounting Screws (2)
Mounting Screws (2)
Figure 4–9 RX23 SCSI ID Switch Location
5. To install the new RX23 drive, reverse the removal procedures in
Section 4.6.