Technical data

VAXstation 3100 (Model 38) System 33
NOTE
The TZ30 drive plate lever may have shipping material under
it. If it does, remove the shipping material and discard it
before performing the next step.
3. Simultaneously press down on the drive plate lever under the TZ30
and slide the drive toward the lever until you can lift the drive from
the plate.
4. Locate the SCSI ID switch settings 1, 2, 3, and 4 on the side of the
drive as shown in (Figure 4–7).
Record the SCSI ID switch positions on the drive so you can set the
ID switches on the replacement drive to the same positions. Usually,
the switches are set to SCSI ID 5 as shown in (Figure 4–7).
MLO-002890
4
3
2
1
SCSI ID 5
1
2
3
4
1
2
3 4
Off (Right)
Switch Positions:
On (Left)
MA-X0855-89
Figure 4–7 Setting the TZ30 SCSI ID Switches
5. To install the new tape drive, reverse the removal procedures in
Section 4.5.
4.6 RX23 Diskette Drive Removal
To remove an RX23 diskette drive:
1. Remove the system box cover (Section 4.3).