Manualshelf

Technical data

ManualsBrandsDigital Equipment Corporation ManualsComputer equipmentVR297
31323334353637383940
VAXstation 3100 (Model 38) System 31
4. Simultaneously press down on the drive plate lever and slide the drive
toward the lever until you can lift the drive from the plate.
5. Turn the drive over and locate the SCSI ID jumper settings E1, E2,
E3, and E4 as shown in (Figure 4–5).
Record the positions of the jumpers on the drive so you can set the
jumpers on the replacement drive to the same positions.
E4
E1
E2
E3
MA-X0798-88
SIGNAL
CONNECTOR
CONNECTOR TO
HDA MODULE
POWER
CONNECTOR
Figure 4–5 Setting the SCSI ID on the RZ22
6. To install the new drive, reverse the removal procedures in
Section 4.4.