Specifications

Connect Expansion Boxes to the System Unit
For each SCSI connector on the system unit, perform the
following steps:
1. If necessary, follow the instructions that came with your
worksystem software to shut down the software.
2. Turn off the system unit and any expansion boxes.
Press the 0 on the on/off switch on the BA42 storage
expansion box, TK50Z tape drive expansion box, and
RRD40 optical compact disc drive expansion box.
Press and release the on/off switch on the TLZ04 tape
drive to turn it on and off.
3. Position the small metal connector on the system-unit-to-
expansion-box cable so the flat side of the connector is on
top, as shown in Figure 5-6.
4. Push the cable connector into the SCSI connector until it
clicks into place.
WSE2I061
SCSI connector
W 359
Hz 50-60
A 7.9/4.2
V~100-120/220
V~220-240 A 1.7
V~100-120 A 3.0
0
2
g i t a l
3
2
1
B
G
R
Figure 5-6. Attaching a system-unit-to-expansion-box cable to a SCSI
connector on the system unit
External Storage Options: Hard Disk, Floppy Disk, Tape, and Optical Compact Disc Drives 5–9