Specifications

6. Position the option module so it is parallel to the bottom of
the system unit, with its system unit slot connector facing
down and its option cable connector facing the option-slot
opening in the back of the system unit, as shown in
Figures 4-11 through 4-13.
7. Move the option module cable connector through the option
slot opening in the back of the system unit.
8. Firmly push the system unit slot connector onto the support
posts and down into the option slot connector.
9. Find the support post screws that came with your option
module.
10. Insert one screw into each support post hole on the option
module. Turn each screw to your right until the module is
firmly in place.
11. Use the two screws that held the metal cover over the
option slot to hold the new option cable connector in place
against the back of the system unit.
12. Remove the antistatic wrist strap from your wrist and from
the system unit.
13. Replace the cover on the system unit and turn on the
system unit and monitor.
Internal Hardware Options 4–17