Specifications

10. Replace the metal bracket and the two screws that hold it
in place.
11. Remove the antistatic wrist strap from your wrist and from
the system unit.
12. Replace the cover on the system unit.
13. First turn on the monitor, then the system unit.
When the system unit completes the power-up self-test
successfully, the console prompt appears on the screen.
14. Type t 7/mem followed by a space and the number of the
memory slot into which you have just installed the memory
module.
For a memory module in slot 2, type t 7/mem 2, and so on.
A display similar to the following slowly appears on your
screen as the test progresses:
**\
When the test has completed successfully, the console
prompt (>>) appears at the end of this display.
If something other than the console prompt appears, turn
to Chapter 9 of this guide for troubleshooting instructions.
To remove memory modules
1. If necessary, follow the instructions that came with your
worksystem software to shut down the software.
2. Turn off the system unit by pressing the 0 on the on/off
switch on the back of the unit.
3. Remove the cover from the system unit.
Internal Hardware Options 4–9