Specifications

Table 9-7 (Cont.). Test Error Codes for Base System Modules
Error Code Action
mem The problem is in the memory module or the system module.
Make sure the memory modules are firmly seated on the system
module.
If the test still fails, run the system memory test for all memory
modules. Type t7/mem * and press Return. This test, which checks
the operation of each memory module, takes several minutes for each
module tested.
The number in the parentheses in the error message that appears
on the screen is the number of the slot that contains a bad memory
module. Replace any modules the memory test indicates are bad.
If the system reports that all memory modules are bad, remove them
all and insert a memory module that you know is good. Run the
memory test again. If the memory test still fails replace the system
module and chassis.
misc/kbd
misc/mouse
The problem is in the keyboard, mouse, keyboard-mouse cable, or the
system module.
Be sure that the keyboard and mouse are attached correctly to the
keyboard-mouse cable and the keyboard-mouse cable is attached
correctly to the system unit.
If the test still fails and the error message is misc/kbd, replace the
keyboard. If the test still fails and the error message is misc/mouse,
replace the mouse.
If the test still fails after the problem item is replaced, try a new
keyboard-mouse cable.
If the test still fails, replace the system module and chassis.
(continued on next page)
Troubleshooting 9–13