Specifications

5. Position the 25-pin connector on the adapter so the Digital
logo is on top as shown in Figure 7-4.
6. Press the adapter connector all the way into one of the
communications connectors on the system unit and turn the
screws to your right to tighten them.
7. Position the connector on the end of your device cable so
the clip is on your left.
8. Push the cable connector into the connector on the adapter
until the cable connector clicks into place.
WSE2I058
Communication device
cable connector
communications
connector
Clip
Adapter
0
1
2
W 359
Hz 50-60
A 7.9/4.2
V~100-120/220
V~220-240 A 1.7
V~100-120 A 3.0
PMAG-C
d i g i t a l
3
System unit
Figure 7-4. Using an adapter to connect a communication device to
the system unit
External Communication Options: Printers, Plotters, Modems, and Console Terminals 7–7