Specifications

Installing a Device That Has a 25-Pin Connector
1. Follow the instructions that came with your device to
perform these tasks:
Be sure the device is turned off.
Set up the device and attach the cable and power cord
that came with it.
Set the proper baud rate and control settings.
2. If necessary, follow the instructions that came with your
worksystem software to shut down the software.
3. Turn off the system unit by pressing the 0 on the on/off
switch on the back of the unit or by turning off your power
strip if you are using one.
4. Connect the free end of the device cable to the system unit
as shown in Figure 7-2.
a. Align the widest part of the cable connector with the
widest part of one of the communications connectors on
the system unit.
b. Press the cable connector all the way into the connector
on the system unit and turn the screws to your right to
tighten them.
External Communication Options: Printers, Plotters, Modems, and Console Terminals 7–3