Service manual

72 VAXstation 3100 (Model 76) System
4.2.12 Mouse Removal
Disconnect the mouse from the back of the system box (refer to
Figure 4–29).
CAUTION
Do not remove or unplug the keyboard, mouse, printer, or
terminator without turning the power OFF. If the system is up
and running, use the proper shutdown procedure prior to halting
the system.
NOTE 1
The mouse and the tablet are single FRUs. Do not try to
disassemble them.
NOTE 2
The mouse must always be plugged directly into the back of the
unit.
4.2.13 Printer Removal
CAUTION
Do not remove or unplug the keyboard, mouse, printer, or
terminator without turning the power OFF. If the system is up
and running, use the proper shutdown procedure prior to halting
the system.
To remove a printer:
1. Switch the printer’s power switch OFF.
2. Disconnect the printer cable from the back of the system box (refer to
Figure 4–29) or from the back of the printer.
3. Refer to the specific printer’s pocket service guide for troubleshooting
and removal and replacement procedures for the printer.