Service manual

VAXstation 3100 (Model 76) System 65

7. Remove the system module by carefully popping up the two front

corners off the two locating posts as shown in Figure 4–24.

CAUTION

ROM chips are static sensitive devices. An antistatic

wriststrap should be worn while removing or replacing a

ROM chip.

MA-1328-90.DG

Locating Post

Phillips-head Screws (3)

Phillips-head Screws (6)

System Power Cable

Figure 4–24 Removing the System Module

8. Remove the memory SIMMs (refer to Section 4.2.7).

9. Use either a ROM puller or slide a small screwdriver under each end

of the Ethernet ID ROM, and carefully lift the ends until you can

remove the ROM from the system module. Figure 4–25 shows the

Ethernet ID ROM.