Service manual

64 VAXstation 3100 (Model 76) System
4.2.8 System Module Removal
To remove a system module:
1. Disconnect all cables from the back of the system box.
2. Remove the system box cover (refer to Section 4.2.1).
3. Remove the drive plate (refer to Section 4.2.5).
4. Remove the graphics coprocessor module (if installed) from the system
(refer to Section 4.2.6).
5. Disconnect the system power cable from the system module by
releasing the lock on the connector (refer to Figure 4–23).
MA-1382-90.DG
Locating Post
Locating Post
Phillips-head Screws (3)
Phillips-head Screws (3)
Phillips-head Screws (6)
System Power Cable
Figure 4–23 System Module
6. Remove the twelve Phillips-head screws from the system module as
shown in Figure 4–23.