Service manual

60 VAXstation 3100 (Model 76) System
4.2.6 Graphics Coprocessor Module Removal
To remove the graphics coprocessor module:
1. Remove the system box cover (refer to Section 4.2.1).
2. Remove the drive plate (refer to Section 4.2.5).
3. Remove the graphics coprocessor module from the four standoffs (refer
to Figure 4–20).
CAUTION
If you have an SPX color graphics accelerator, there is an IC
(on the SPX graphics module) whose pins are susceptible to
bending near the rear corner furthest from the power supply.
Be extremely careful in handling this module so as not to
cause permanent damage.
Graphics Coprocessor
Connectors Underneath
Module
Standoffs
Standoffs
Module
MA-1326-90.DG
Standoff
Figure 4–20 Removing the Graphics Coprocessor Module