Service manual

58 VAXstation 3100 (Model 76) System
MA-1354-90.DG
SCSI Terminator
Figure 4–18 SCSI Terminator
6. Free the five captive screws and loosen the three slide mount screws
on the drive plate as shown in Figure 4–16. Do not remove the screws
from their mountings.
7. Slide the drive plate (with the drives) forward approximately 1/2-inch
and then lift it up and off the system box. Feed through the disk
power cable as shown in Figure 4–19. Set the plate aside.
8. To install the drive plate, feed through the disk power cable as
shown in Figure 4–19 and then continue by reversing this removal
procedure.