Service manual

VAXstation 3100 (Model 76) System 55
4.2.5 Drive Plate Removal
You do not have to remove any devices mounted on the drive plate to
remove the drive plate from the system box.
To remove the drive plate:
1. Remove the system box cover (refer to Section 4.2.1).
2. If the drive plate has devices mounted on it, complete all the following
steps. If the drive plate has no devices mounted on it, proceed to step
6.
3. Disconnect the disk power cable (P/N 17–02220–01) from the power
supply (refer to Figure 4–16).
4. Remove the SCSI cable from the system board by spreading the tabs
and pulling straight up.