Service manual

Utilities 31
If the password feature is enabled, the prompt appears for the console
password. The password typed in is not displayed on the screen. If the
correct password is entered, the workstation is then in privileged mode
with access to all commands.
If an incorrect password is entered, the following message is displayed:
?23 ILL CMD
3.4.4 Learning the Status of the Password Feature
To check on the status of the password feature, use the following
command:
>>> SHOW PSE
Ifa1isdisplayed, the feature is enabled. Ifa0isdisplayed, the feature
is disabled.
3.4.5 Exiting Privileged Mode
The following console commands, when executed while the console is in
the privileged mode, cause an exit from privileged mode before any other
operations begin:
• BOOT (with any supplied parameters)
• CONTINUE
• HALT
• START
Once privileged mode is exited, you must use the LOGIN command and
correctly enter the console password to regain the privileged mode.
3.5 Utility Differences for the Model 76
The following utilities are different from those used on the VS3100 Model
30, 38, 40, and 48:
• T 55 has been replaced with show ESTAT.
• T 70 has been replaced with T 76.