Service manual

30 Utilities
Reenter the new password and press
Return
. Again, note that the
password is not displayed. If the verification password matches exactly
the password you first entered, then it becomes your new password. If
the two passwords do not match, then the command fails and the console
displays the following error message:
?31 ILL PSWD
3.4.2 Enabling the Password Feature
Use the SET PSE to enable or disable the password feature. The form of
the command is:
>>> SET PSE #
In place of #, enter a 1 to enable the feature. Entera0todisable the
feature.
If you enter something other than 1 or 0, the following error message is
displayed:
?24 INV DGT
If you have not yet used the SET PSWD command to choose a password,
the following error message is displayed:
?33 NO PSWD DEF
3.4.3 Placing the Workstation in Privileged Mode
If privileged mode is selected, it is necessary to type the password at the
LOGIN command to enable console commands.
>>> LOGIN
If the password feature is not enabled, the console displays the following
error message:
?32 PSWD NOTEN