Service manual

24 Utilities
Table 3–5 PV_SCS_FMT_ERR# Error Codes
Error
Code Description of Code
04 Bad status returned by device
06 Not enough sense data returned
08 Bad sense key returned by device
0A Too many retries of this command, failed after request_sense
0C Attempt to select host
0E No req was received within timeout period
10 Entered the same phase twice
12 Device in the command phase is out of order
14 Device in the data_in phase is out of order
16 Unexpected entry in the data_in phase (the command should not
go in the data_in phase at all)
18 Device in the status phase is out of order
1A Device in the message_in phase is out of order
1C Device in the data_out phase is out of order
1E Unexpected entry in the data_out phase (the command should not
go in the data_out phase at all)
20 Entry in unsupported phase 4
22 Entry in unsupported phase 5
26 Device has not signaled a phase
32 No data transferred when receiving bytes
34 AIP bit not set soon enough
3C Selection failed
4C Too many REQs
4E Timeout waiting for bus after command (req is not set)
60 Not enough inquiry data returned by device
68 Reset did not clear bus
6A Attempt to access SCSI-B on ST506 board
6C Unexpected message_out phase