Service manual

Self-Tests 91
Target
Status
Code Status Description
B8 Error: Wrong interrupt following status in DMA test
BA Error: scd_cnt not zero following status in DMA test
BC Error: DMA not complete after EOP in status phase (ACK not
clear soon enough)
C0 Error: Status<dmaend> not cleared by clearing mode<dma> at
start of message_in phase in DMA test
C2 Error: Target failed to set message_in phase in DMA test
C4 Error: Timeout waiting for DMA complete in message_in phase
in DMA test
C6 Error: No status<dmaend> following message_in phase in DMA
test
C8 Error: Wrong interrupt following message_in phase in DMA test
CA Error: scd_cnt not zero following message_in phase in DMA test
CC Error: DMA not complete after EOP in message_in phase (ACK
not clear soon enough)
D0 Error: Status<dmaend> not cleared by clearing mode <dma> at
end of DMA test
D2 Error: Bus not free soon enough at end of DMA test
Additional debug information in disk/tape buffer.