Installation guide

SCSI controller (cntl) test
To test the operation of a SCSI controller from the
console prompt, enter
t slot_number/scsi /cntl
Table 2-3 SCSI controller error codes
(code: description) Meaning
(1: rd cnfg) Values written to and
read from configuration
register did not match.
(2: fifo flg) First in, first out (FIFO)
load and FIFO flags did
not match.
(3: cnt xfr) Write and read operation
on TCL register reported
a mismatch.
(4: illg cmd) Command was illegal
and did not generate an
interrupt.
(5: int reg) Controller cannot clear
internal interrupt
register.
(6: rd cnfg) Mismatch occurred when
reading the write/read
configuration register.
2–8 TROUBLESHOOTING TOOLS