Technical data

Installing the TURBOchannel Option, Continued
Remove the
Option Plate
Remove the option plate that covers the TURBOchannel option
port opening.
Squeeze the tabs together, then pull the plate out, as shown by
the arrows in Figure 6–20.
Figure 6–20 Removing the Filler Plate
Touch here
Masse
Toque aqui
Hier beruhren
MLO-008524
Remove the
Graphics
Board
If there is a a graphics board present, you need to remove it.
Follow the steps shown in the Removing the SPXg 8-plane Option
procedure.
Insert the
Adapter Board
Insert the four plastic standoffs in the correct location, then align
the TURBOchannel adapter board holes over the standoffs, as
shown in Figure 6–21. Press the board down, snapping the board
down over each standoff to secure it.
Continued on next page
6–57