Technical data

SPXgt 24-Plane Option, Continued
Installing the
SPXgt 24-Plane
Option
Reassemble the option assembly with the new FRU as follows:
Step Action
1 Align the graphics module and system module inter-
module connectors. Mate the connectors by pressing down
on the module. The module latches should snap into place
to secure the module.
2 Align and mate the frame buffer with the graphics
module. The frame buffer module tail bracket should
snap over the ridge on the disk drive H-bracket.
3 Install the RFI gasket.
See Figure 6–13. Press the RFI gasket over the video
connector on the graphics subsystem processor module.
The angled top and sides of the gasket face away from the
connector bracket. This compresses the gasket between
the connector and system box when the option is installed.
4 See Figure 6–16. Carefully tilt the assembly into position
. The two hooks on the system box subchassis slip
through the square holes in the lower curve of the
connector bracket. The bottom surface of the connector
bracket sits on the subchassis, held in place by the hooks
and the square ridge on the subchassis. Figure 6–13 is a
detailed side view.
5 With the assembly is position, align the graphics
subsystem processor and system module intermodule
connectors. Mate the connectors by pressing down on the
frame buffer module above the intermodule connectors .
The board latches should snap into place and the frame
buffer module tail bracket should snap over the ridge
on the disk drive H-bracket to secure the 3D graphics
assembly.
Continued on next page
6–37