Technical data

Mass Storage Drive Removal, Continued
Installing a
New Drive
To install a new drive, reverse the steps in RRD42 CDROM Drive
Removal. You do not need to push the tabs to insert the bracket.
The bracket snaps into place if positioned correctly.
RX26 (Diskette)
Drive Removal
This section describes how to remove the RX26 diskette drive.
Figure 6–1 shows the drive location.
Step Action
1 You need to release two tabs.
The first tab is located at the upper right front of the
bracket. The second tab is located behind the screw hole
at the bottom left center of the bracket.
Simultaneously pull the first colored tab on the drive
bracket toward the power supply of the system and push
the second tab to the right.
2 Remove the hard drive.
3 Lift the drive and drive bracket from the system box.
4 Disconnect the SCSI and dc power cables from the drive.
5 Remove the drive from the removable media bracket by
releasing the latches on each side of the bracket. Remove
the drive from the secondary bracket by removing the
four screws from the underside of the RX26 bracket.
RX26
(Diskette) Drive
Replacement
Before installing the new drive, verify the drive type number
setting on the drive. The number settings are as follows:
RX26, Setting is 0
RX23, Setting is 1
RX33, Setting is 2
Figure 6–7 shows the drive type switch location for the diskette
drive. Figure 6–8 shows the diskette drive SCSI ID switch
locations.
Continued on next page
6–16