Technical data

Mass Storage Drive Removal, Continued
Step Action Comment
2 Set the SCSI ID
jumpers of the top
disk drive as specified
in Table 6–1.
The jumpers are used in the
following manner:
Install the jumper for IN
Remove the jumper for
OUT
3 Install a new drive by
reversing the steps in
the Hard Disk Drive
Removal procedure.
Note: When installing a drive
into the bracket, you must apply
pressure on the drive for it to
seat properly.
Figure 6–3 RZ23L Disk Drive SCSI ID Jumper Location
E1
E2
E3
E1
E2
E3
MLO-005907
Continued on next page
6–10