Technical data

Mass Storage Drive Removal, Continued
Step Action Comment
6 Lift the drive from the
bracket.
7 Match the SCSI ID
with the error code to
verify that the failed
drive was removed.
Figure 6–3 and Figure 6–4
show the disk drive ID jumper
locations. Table 6–1 contains
the SCSI jumper settings.
8 Remove the drive
mounting plate.
9 Remove the second
hard disk drive from
the bracket if one is
present.
Hard Disk Drive
Replacement
Use the following procedure to replace hard disk drives in the
system box:
Step Action Comment
1 Verify the SCSI ID
setting on the drive.
The SCSI jumpers allow you to
select a distinct ID number for
each SCSI device. It is essential
that each device have a unique
SCSI ID (0-7). Figure 6–3 shows
the location of the RZ23L hard
disk drive SCSI ID jumpers (ID
number 4 selected). Figure 6–4
shows the location of the RZ24
disk drive SCSI ID jumpers.
Continued on next page
6–9